Pianos regularly make movers yearly list of items that are most regularly harmed. Grand pianos are particularly bothersome. Practicing the following procedures for taking apart, cushioning and filling grand pianos will avoid damage, lower claims cost, and enhance consumer satisfaction.
1) At least three individuals are required to deal with a child grand piano. If the baby grand piano needs to go up or down stairs or if a full or show grand piano needs to be carried, a minimum of 4 people are required.
2) Constantly finish a extensive and accurate stock. It might be required or more suitable to use a visual stock to sufficiently describe and show pre-existing damage.
3) As various parts are taken apart, please place all hardware in a correctly labeled parts bag and then place the parts bag in a "Components Box".
4) Eliminate the music rack (lyre) from its track by pulling it toward the keyboard. Wrap it in a tidy furniture pad.
5) Disconnect the lid by getting rid of the hinge pins. Wrap the lid in a tidy furniture pad.
6) Eliminate the prop that holds the lid open and wrap it in a tidy furniture pad. The prop has a hinge pin and is in 2 pieces.
7) Remove the pedal assembly and wrap it in a tidy furnishings pad. The braces at the back of the assembly rest in slots at each end. When removing the screws, please beware not to drop the braces. In addition, please be especially mindful with the push-rods so that they will not get bent. As you deal with the piano, number the push-rods from delegated right as "1", "2", and "3", by placing a piece of masking tape with the appropriate number on each rod. Note: If masking tape is unavailable, please use correctly identified parts bags for this purpose. When reassembling at destination, please make sure to put the rods in the right order so that the pedals will work effectively.
8) Pad the piano by putting a clean rolled furnishings pad (stretch-wrap the pad to prevent it from unrolling) on the cover of the keyboard to prevent it from tumbling open while you manage the piano. Note: Please make sure that the surface of the piano is dust-free prior to padding it.
9) Position a piano board and attach the straps so that it is prepared to receive the piano. The raised brace on the piano board need to be check my blog at the keyboard end of the piano.
10) Eliminate the left front leg by placing one person below the piano at the left end of the keyboard. The other 2 individuals should support the left front corner. The individual underneath the piano should turn the keeping block so that the long end points far from the leg. The screws, if there are any, need to then be eliminated. The "below" person must then extricate the piano before in fact eliminating the leg. Make certain to have 2 people lifting the corner of the piano while the third individual gets rid of the leg. Note: Please make certain to keep in mind which legs were removed from which positions because some pianos have legs that are not interchangeable.
11) Location the piano on the piano board by decreasing the "leg-less" end onto the board. Please make certain to raise the entire piano somewhat while completing this maneuver to prevent undue pressure on the remaining, connected legs as the piano pointers. Raise the piano to an upright position on the board. Note: Please ensure that the soundboard is secure prior to raising. Make sure that the piano is centered snugly versus the brace at the end of check here the piano board. Note: Never leave the piano ignored. Always have at least one individual holding the piano steady at all times.
12) Get rid of the two staying legs and wrap them in tidy furniture pads. These legs are kept in place by a "crucial and slot" arrangement. To eliminate the leg, slide it inward towards the center of the piano up until it comes out of the slot.
13) Protect the piano to the piano board by bringing completions of the straps together and fastening them. Location folded burlap pads over the furnishings pads but under the straps to offer extra protection to the edges of the piano. To prevent the strap near the narrow end of the piano from slipping off, connect the loose ends of the two straps together.
14) To move the piano over a flat, level surface, tilt the piano and piano board and location a four-wheel dolly under the center of the piano board.
15) To move the piano up or down stairs, utilize the piano board as a skid. After adequately padding the stairs for protection against home damage, position the keyboard end of the piano towards the bottom of the stairs. Attach a hump strap to the top end of the piano board to avoid the piano from slipping.
16) To fill the piano, leave it on the piano board and location it in a tier as the very first base product with the keyboard dealing with the wall of the preceding tier. The best place to pack the padded lid is between the piano and the preceding tier or between the wall and the piano.
Grand pianos represent a significant challenge, they can be moved without damage by using typical sense and practicing the treatments noted above.